MAN page from Fedora 25 ntp-perl-4.2.6p5-44.fc25.noarch.rpm
Section: Maintenance Commands (8)Index
ntptrace - trace a chain of NTP servers back to the primary source
SYNOPSISntptrace [ -n ] [ -m maxhosts ] [ server ]
ntptrace is a perl script that uses the ntpq utility program to follow the chain of NTP servers from a given host back to the primary time source. For ntptrace to work properly, each of these servers must implement the NTP Control and Monitoring Protocol specified in RFC 1305 and enable NTP Mode 6 packets.
If given no arguments, ntptrace starts with localhost[char46] Here is an example of the output from ntptrace:
% ntptracelocalhost: stratum 4, offset 0.0019529, synch distance 0.144135server2ozo.com: stratum 2, offset 0.0124263, synch distance 0.115784usndh.edu: stratum 1, offset 0.0019298, synch distance 0.011993, refid 'WWVB'
On each line, the fields are (left to right): the host name, the host stratum, the time offset between that host and the local host (as measured by ntptrace
; this is why it is not always zero for "localhost
"), the host synchronization distance, and (only for stratum-1 servers) the reference clock ID. All times are given in seconds. Note that the stratum is the server hop count to the primary source, while the synchronization distance is the estimated error relative to the primary source. These terms are precisely defined in RFC-1305.
- Turns off the printing of host names; instead, host IP addresses are given. This may be useful if a nameserver is down.
This program makes no attempt to improve accuracy by doing multiple samples.
The official HTML documentation.
This file was automatically generated from HTML source.
- SEE ALSO
This document was created byman2html,using the manual pages.