Section: [FIXME: manual] (1)
trace-cmd-stop - stop the Ftrace Linux kernel tracer from writing to the ring buffer.
The trace-cmd(1) stop is a complement to trace-cmd-start(1). This will disable Ftrace from writing to the ring buffer. This does not stop the overhead that the tracing may incur. Only the updating of the ring buffer is disabled, the Ftrace tracing may still be inducing overhead.
After stopping the trace, the trace-cmd-extract(1) may strip out the data from the ring buffer and create a trace.dat file. The Ftrace pseudo file system may also be examined.
To disable the tracing completely to remove the overhead it causes, use trace-cmd-reset(1). But after a reset is performed, the data that has been recorded is lost.
trace-cmd(1), trace-cmd-record(1), trace-cmd-report(1), trace-cmd-start(1), trace-cmd-extract(1), trace-cmd-reset(1), trace-cmd-split(1), trace-cmd-list(1), trace-cmd-listen(1)
Written by Steven Rostedt, <m[blue]rostedtAATTgoodmis.orgm>
Copyright (C) 2010 Red Hat, Inc. Free use of this software is granted under the terms of the GNU Public License (GPL).
- SEE ALSO
This document was created byman2html,using the manual pages.